MCS2 BENEFITS
•    DRIER REEDS SO YOU PLAY FOR LONGER
•    CONSISTENCY OF AIR PRESSURE
•    EASY-ADJUST QUICK STOP DRONE VALVE
•    EASY TO INSTALL AND MAINTAIN
•    NON-BULKY, LIGHTWEIGHT SYSTEM

FITTING the MCS2 system – A tight fit of the MCS2 is essential

1.    Pull stocks OUT through the collar on the bag.  (DO NOT push stocks back into the bag as this may tear the collars and/or the bag)

2.    Fit the cup of the FLEXI-JOINT into the groove at the bottom of the stock; tape to secure if necessary.

3.    Re-fit the stocks as normal, pushing through from the inside of the bag until cup rests against the collar

4.    Push cartridge into the connector.

5.    Insert complete unit (cartridge and connector) into the flexi-joint, pushing firmly home.

ALTERNATIVE METHOD OF FITTING (not using flexi-joint)
Hemp up CONNECTOR and insert directly into drone stock, ensuring a tight fit.  Then insert CARTRIDGE firmly into CONNECTOR.  
When removing the cartridge, the connector should remain in the stock.

DRONE VALVE – assists with clean starts and cut-offs

Adjusting
The valve comes pre-fitted (in the connector) and pre-set. 
Small adjustments can be made with a screwdriver:
•    Turn clockwise for a more effective cut-off and a more mellow drone sound
•    Turn ant-clockwise for freer airflow and greater volume

Removing
Should you wish to remove the valve, use the white tube to push the VALVE out of the CONNECTOR as shown. 
Re-fitting
If you need to re-fit the valve, use the white tube to push the VALVE into the CONNECTOR as shown. 
 

CARTRIDGE – captures moisture to help keep reeds dry
Maintenance
After use, remove cartridge from the bag (leaving connector in place) and allow to dry naturally in a warm place.  
Do not microwave or oven dry as this will reduce the effectiveness of the gels.  
Allow to dry thoroughly for maximum effectiveness.  

Replacements/Spares
Replacement gel or complete cartridges are available through your local agent or on our website (www.highlandreeds.com).